The process of mark out is deliberate and prepares parts for assembly by indicating their position. A mark can be anything from a blemish or smudge to a deliberate mark that conveys shipping (or other) information. Woodworkers, carpenters, masons, machinists, and other tradespeople distinguish between marking (or markings) and mark out. Construction projects such as a house, furniture, stairs, or a boat require a mark out sequence. To “mark out” means to draw lines (and sometimes symbols) on wood, metal, or masonry to indicate how and where pieces are joined. Reposition the saw horses to avoid cutting into them, then advance the cut and repeat the procedure at the second saw horse. Overhang the plywood on the saw horses, begin your cut, then stop and look underneath to see where you are relative to the horse. When ripping plywood to width using a circular saw, whether it’s a track saw or a circular saw guided by a straight edge, be mindful of where your saw horses are. Next, crosscut the parts to the dimensions shown in the drawing. Use the opposite factory edge to make the second rip cut. Use one factory edge to make one rip cut. That is, cut along the sheet’s long axis with a circular saw. It comes down to this: Using the factory edges as your reference line, rip two pieces of plywood to 9-¾ inches wide. It’s a simple matter to cut the organizer’s parts from a sheet of plywood.
Coarse-thread pocket screw (1-inch) for ½-inch stock: Kreg SPS-C1.Paint-grade pocket screw plugs: Kreg P-Micro-PNT.Based on these dimensions, you can build two organizers from one sheet of plywood.īuild Your Own DIY Fly Trap DIY Closet Organizer Tools and Supplies
DIY MITER SAW BENCH PLANS FREE
Our plans provide size and spacing information, but feel free to make it any size you like. You can also join the parts with 6d or 8d finish nails and drive wood screws (or coarse-thread drywall screws) through the sides and into the ends of the dividers. We butted the parts together and fastened them with pocket screws. We applied one coat of cabinet undercoater for the primer and two coats of satin enamel paint for the topcoat. The organizer’s design is such that you can hang it on a wall horizontally or vertically (if the floor is smooth and flat, you can stand it). We dressed up the its front edge by applying iron-on birch edge banding. We built the closet organizer you see here from ½-inch Baltic birch plywood, but you could also use ¾-inch-thick plywood. These work well for storing and neatening articles and garments that aren’t easy to hang, such as gloves, sportswear, workwear, hats, and shoes. But if you can’t add more square footage to your living area, at least you can add storage area by building a DIY closet organizer, a little plywood box with dividers.